Can you install the ozone generator by yourself, or need technician staff or a plumber, after read the this Hot tube SPA Ozonator Installation Guide, you will know how to replace the ozone generator for your hot tube SPA.
Beforeyoubuy:
1, check the power voltage: 110V or 200V, it is most important, over -voltage may get fire and under the voltage cannot make the ozonator working
2, buy qualified Ozonator, on the market, the hot tube spa suppliers or after sales services always recommend their most profitable one, so normally expensive there are lots of models and brands ozonators for your to choose, choose the UL certificated at least. Especially the ozonator manufacturer like Toro Verde ozone, which are supplying to the top brands, the quality will same level.
3, Turn the power off too the spa
4, ALL ozonators are supplied with power cords and are hooked to the equipment control box via a supplied cord end, or they are hard wired directly into the control box. Look on the side of your control box where everything plugs in, if you see an empty slot that will except a (3) prong plug then most likely this is the receptacle for the ozonator. Please look at the selection of cord end to select the proper pattern Once you receive the ozonator, find a suitable mounting location that will keep it up and out of any water. The next step is VERY IMPORTANT, failure to do so will jeopardize the new ozonator and void the warranty. You will want to create a "loop" (Hartford Loop) in the tubing and install it as high as possible under the spa to keep water from backing up into the ozonator as shown below.
If your spa is 'ozone ready' then one of two things are apparent
If mentioned above, then the next step is to identify the cord end that matches the receptacle on your control box, then purchase the ozonator that matches the cord end you chose. Spa Parts Ltd. recommends using a TORO Verde Ozone unit. If the tube is not drawing a suction, then please follow the instructions below.